How To Make Homemade Bucket Bongs
Experience classic homemade bucket bong smoking
A. What you'll need:
Bucket filled with water
2-litre bottle with cap
Bowl piece
B. Assembly of your homemade bucket bong
Cut the bottom of the 2-liter plastic bottle.
Take the bottle cup, and puncture a hole in which you'll fit in the bowl
piece tightly. This can later be air tightened with some candle wax if
needed.
Fill the bucket with cold water at the level needed for the bottle to
be almost full when it is rested on the bottom of the bucket.
C. Smoking
Uncap the bottle and place it bucket so that it is almost full with water.
Fill the bowl, which should be screwed in the bottle cap and close the
bottle with it.
Align your ignited lighter over the bowl and gradually pull the 2lt..
bottle up -
this will cause air to rush through the burning bowl, replacing the water
that was inside before, with rich smoke.
Once the bottle is full, remove the bowled cap and place your hand over
the top. It's smoke time! Exhale all air from lungs, then put your mouth
over the opening and let the bottle fall to the bottom of the bucket.
Open your lungs and let the pressure from the water filling the bottle
shotgun the smoke into your lungs.
Now, if you liked that believe us you will love your new BUKKETs, which
are based on the same principals but is much simpler, fun and cleaner,
check it out now !
|